CAN YOU DETERMINE WATER HARDNESS FROM CONDUCTIVITY OR TOTAL DISSOLVED SOLIDS MEASUREMENTS?

 CAN YOU DETERMINE WATER HARDNESS FROM CONDUCTIVITY OR TOTAL DISSOLVED SOLIDS MEASUREMENTS?

General Water hardness is related to the dissolved minerals in the water.  General hardness is a misleading term that is often confused with carbonate hardness or temporary hardness, which is actually related to alkalinity and relates to the "buffering capacity" of the water (its ability to resist pH changes).  

This means that if the carbonate hardness is high then the pH will be extremely stable or alternatively if the carbonate hardness is low the pH of the water will be able to fluctuate easily.  

Water hardness is the measurement of the amount of ions which have lost two electrons (divalent cations) dissolved in the tested water and is therefore, related to total dissolved solids.  

The more divalent cations dissolved in the water the "harder" the water.  

Generally the most common divalent cations are calcium and magnesium, however other divalent cations may contribute including iron, strontium, aluminum, and manganese. 

Typically the other divalent cations contribute little to no appreciable additions to the water hardness measurement. 

A stream or river's hardness reflects the geology of the catchment's area and sometimes provides a measure of the influence of human activity in a watershed.  

For example, sites that have active or abandoned mines nearby often have higher concentrations of iron ions in the water resulting in a very high hardness degree.

Total dissolved solids (TDS) refers to a measure of all inorganic solids dissolved in the water.  This means that it will measure ions that contribute to water hardness, like calcium, but also those that do not, like sodium.  

The TDS measurement is a better reflection of the total mineral content of the water rather than a water hardness measurement.  

However, for estimation purposes, the water hardness can be roughly calculated by dividing the ppm (parts per million) measurement of the TDS by 10 giving a hardness value with an error of only 2-3 French degrees.  

You can use TDS to determine whether the water will be toxic. i.e much dissolved solids including metals.

TDS measurements can also be derived from Electrical conductivity measurement.

Electrical Conductivity is similar to TDS measurements. EC is a measure of the ability of a substance to conduct electric current.  Conductivity measurements offer a rapid and non-destructive way to measure ion content in the sample.  The conductivity measurement is made with an electronic sensor or meter in micro/milli-Siemens per centimeter or ppm. 

Conductivity increases with increasing ion content, which means that in most cases it gives a good approximation of the TDS measurement using the conversion factor of 1 ppm = 2 uS/cm.  Conductivity is temperature sensitive and is typically standardized to 25°C. 

While conductivity is a convenient way to get an approximation of the hardness of water it does have the drawback of combining all ions in the measurement, including those that do not contribute to the water's hardness.  This hardness approximation gives an error similar to the TDS measurement of 2-3 French degrees of hardness.

Can you measure water hardness with a conductivity sensor or TDS sensor?  

TDS, Temperature and Hardness plays a vital role in Hactery. It'll determine whether your eggs are going to hatch well.

TDS, Temperature, PH and hardness will determine whether your fries are going to survive till they become fingerlings and Juveniles.

To get your water tested 

#Call/Whatsapp/Signal 08138570184

At home on site water testesting available only in Lagos.

Free home delivery service 

(No delivery Fee) available for now.

Delivery fee may apply soon without notice.

You can also get your water tested at our office.

#Call/Whatsapp/Signal 08138570184